P
Phil
got a couple to replace and just wondering if anyone had used them before and if any of the big wholesalers stocked them? not used them before myself. look pricey though
-
Please checkout the new poll we will be pushing hard, and want some good stories to come out of this
result are public - you can change your vote over time, which might genuinely be the case from time to time.
Discuss rako, anyone used them before in the Australia area at ElectriciansForums.net
Share this page
OP
pennywise
Pretty easy to use, have a look at their website they have all their wiring diagrams and lighting solution in PDF form I believe. They are quite expensive have a look on mr resistors website for a rough RRP, Eds get hold of it quite easily
http://www.mr-resistor.co.uk/controls.aspx?t=467
Wise control maybe slightly cheaper
http://www.mr-resistor.co.uk/controls.aspx?t=467
Wise control maybe slightly cheaper
Last edited by a moderator:
OP
Phil
thanks mate
Reply to rako, anyone used them before in the Australia area at ElectriciansForums.net
Share this page
Similar Threads
Hi fellow Sparkies! I've never posted before on this site and now I've retired its a bit late to frequent the pages of this forum but I need to...
Hi all. I'm going to replace some sockets during a routine redecoration of our lounge including replacing some singles with doubles with USB...
Thinking of getting a Runpotec XB300 cable dispenser, as my yellow framed tripod thing is unsatisfactory for all the usual reasons.
You can...
I removed my baseboard electrical heaters (1981 installed) due to finishing off the room. When I had a new AC ductwork installed they changed the...
Hi all,
I'm looking for a couple of PIR floodlights to replace old halogen ones, probably around the 50W mark would provide sufficient lighting...
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
YOUR Unread Posts
-
Fuel Gauge needle moving with revs issueThe link you posted is for a regulator/rectifier. Do you mean I should somehow hook it up as per...
- Latest: Tarlow
-
Uh oh...shorted MICC. How scr*wed am I?yes. I was just clarifying what Dave meant by "isolate"
- Latest: johnnyuk
-
can i book appointmentwell this will make you chuckle,this morning sent a customer an email regarding some work they...- Latest: buzzlightyear
This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.