Can you feed 2 radials from one fused spur

[Des 56]

You have diagnosed the problem
You have enquired as to compliance
You have suggested a sensible solution,it will leave the existing sockets as safe as they were when they were on a needless ring final

It may not be an ideal way to wire a radial(if you were starting from new) but 2 branches should be ok
It even has advantage in that the final Zs will be lower than if it was conventional socket to socket jobbie

 

[Dave]

You have diagnosed the problem
You have enquired as to compliance
You have suggested a sensible solution,it will leave the existing sockets as safe as they were when they were on a needless ring final

It may not be an ideal way to wire a radial(if you were starting from new) but 2 branches should be ok
It even has advantage in that the final Zs will be lower than if it was conventional socket to socket jobbie

Thanks Des 56

 

[Dave]

I doubt it does against the Regs as long as circuit protection has not been compromised.

Thanks Westward10