Car wiring loom

[Jonathan Wilkes]

Hi, I've just recently put a 2.0 engine out of a mk1 Mondeo into my mk2 fiesta, I've asked two people if they can sort me either a loom or install the loom for me but keep getting told they will get back to me.
I need someone that can make me a loom with the diagram I have to me it's complicated as I don't know anything about auto electrics but maybe it is simple.

I have attached a diagram of the loom I need making with relays etc.


Thanks Jonny

 

[ruston]

Are the ECU units a straight swap for this change, if not it will be programmed differently.
Anyone undertaking your task would need to see this project ,least of all to see the wiring runs.

 

[Jonathan Wilkes]

No I use the original car loom and use just the engine loom from the Mondeo with the ecu, it's pre pats so I don't have to mess about with keys or imobilisers. I just have to connect the fuel pump up to a relay and connect several other wires but not too sure on how I go about doing so.

 

[ruston]

Easy enough ,any local auto electrician should set that up for you.
Trying to tell you how to do it or guess runs without knowing obstacles to prevent cable damage would be more difficult to be honest.

 

[Marvo]

I'd suggest you'd need an auto electrician. As already mentioned it's the kinda job you'd need to see first hand and car wiring looms that are incorrectly wired or fused are a notorious fire hazard. One false move you could destroy the entire loom beyond repair or even worse set the vehicle on fire.