Henley Block inside fuse box ...:)

[SparkySy]

If that was me and it was an all metal board, I would have just swapped out the MCB's for RCBO's and been done, oh yes and tidying up those cables too what a mess to start with! And he could of split the 25mm earth over two terminals if it wouldn't fit into 1.
Poor from Del, I usually like his stuff but the last couple have made me start to wonder.

 

[Grant1987]

I have no idea why you watch these people. A reducing lug and through crimps, rudimentary stuff to solve the issue.

Spot on ?

 

[Grant1987]

Spot on ?

And I’ve just noticed your promotion well deserved ? you always back up your case And try to educate others like myself without embarrassing them. Can’t fault you

 

[ipf]

I have no idea why you watch these people. A reducing lug and through crimps, rudimentary stuff to solve the issue.

Lovely Jubbly, my friend.....it's Del boy, plonker.

 

[Pete999]

If that was me and it was an all metal board, I would have just swapped out the MCB's for RCBO's and been done, oh yes and tidying up those cables too what a mess to start with! And he could of split the 25mm earth over two terminals if it wouldn't fit into 1.
Poor from Del, I usually like his stuff but the last couple have made me start to wonder.

maybe he has changed his name to DelBoy the Spark, yes the posts have gotten worse,

 

[hasel5]

That is dog rough and guy should be ashamed of himself

 

[Dartlec]

Didn't see this before I listed him in ones I occasionaly watch in another thread - doh!

Not much note of it in the YT comments interestingly - and can't immediately think of a regulation it would break

Certainly a (marginally perhaps) better option than the flat I had to change a CU where they used a bare copper through joint of the sort you use in underground gel joints then wrapped it in tape

 

[lozarus]

This is where being too loyal to one brand can cause you to inadvertantly be blind. Crabtree boards have L/H main switch. MK boards (still abvailable) also have L/H main switch. Even if I hated either of those two makes, I'd probably have just gone down that route bcause the product would be more fit for purpose.

Also I imagine he's far more qualified than me, butI wouldn't dream of giving any conductor a haircut. Really grinds my gears that.

 

[Lister1987]

In a few of his videos it shows he's not got the 'finger on the pulse' as you'd expect (giving a cable a haircut when a reducing lug would have been fine, not knowing about earth leakage clamp meters (maybe not his fault given age and not having them in his day) and stuff you just end up going....'really?'.

I watch them for entertainment, more often that not for things NOT to do. I'm not perfect by any stretch but it shows how distracting the whole YT thing can make you.

I'll say this much, I'm liking @ArtElectrics recent employ, guy strikes me as level headed, a few bad habits no doubt but am seeing him knock the shine off Jordan's work a bit and making Jordan's look sub-par.

 

[gazdkw82]

If that was me and it was an all metal board, I would have just swapped out the MCB's for RCBO's and been done, oh yes and tidying up those cables too what a mess to start with! And he could of split the 25mm earth over two terminals if it wouldn't fit into 1.
Poor from Del, I usually like his stuff but the last couple have made me start to wonder.

The alarms rang pretty quickly for me with Del.