lathe and plaster and downlights!!!

[sparksburnout]

What a bunch of pusseys. Half the ceilings round here are L&P. You have to worry when half of it falls down never mind making a decent hole. I have done loads with a cheapo screwfix holesaw, you just have to do it slow and steady, then speed it up once you have gone through the plaster to take out the laths. The worst bit is all the stuff above in an ageing, sh**ty loft full of pigeon poo.
Don't know what it is but some of them give off a strangely attractive odour when you are drilling them.

 

[NDG Elecs]

I have done a good few with no probs. Always used the Bosch holesaw. I sometimes find it harder to cut out for sockets in L&P without any issues, but ceilings have always been fine. I find the laths can vibrate to hell when doing sockets.

Must be a special mix of super tough plaster you have there!

 

[murray2707]

Had this before with tougher plaster than normal, was almost like a concrete skim. used the holesaw to mark the circle then used a 6mm drill to make a series of holes right round the circle then followed through with the holesaw

 

[Delboybully]

I use the bosch multi construction holesaw. Sails through lathe and plaster. They last for ages!!!! They look like a core drill. More expensive than standard holesaws but much much quicker. Once you use one you will realise what great value for money they are.

https://www.youtube.com/watch?v=g-MPWxmMUl4

Bosch 2608580871 10 Piece Speed Multi Construction Holesaw Set in Case

 

[Dave OCD]

Ever considered what that ancient plaster contains ?

 

[ruston]

Ever considered what that ancient plaster contains ?

I know what coloured the whitewash on the farm lol.

 

[rich.250]

Have done a lot of down lights in lathe and plaster.
Going slow with a hole saw is the best way. Or cut out the plaster first with a padsaw, then get the hole saw on the lathes.
When I was an apprentice we cut them in all by hand no matter what the ceiling was made of...
Just aim smaller than you need as it will get bigger lol


Sent from my iPhone using Tapatalk

 

[ruston]

You have to have an investigation of the ceiling before you start , If there are large areas of 'noisy as you tap ', you have a mountain to climb.

 

[snowhead]

If there are large areas of 'noisy as you tap ', you have a mountain to climb.

And best take a brush, dustpan and large builders bucket up there with you..

 

[ruston]

And best take a brush, dustpan and large builders bucket up there with you..

Aye , and one of the jobs where eye protection is essential.