I have a central machinery belt/disc sander without a switch and the manufacturer could not help replacing it. The sander is 120vac/60hz/3.5a and was told this switch should work out for it but I'm not sure where to connect everything. Thanks for any help ya give.
- Thread starter okonkole
- Start date
-
- Tags
- help installing need help switch
Discuss Need help installing switch on belt sander. in the DIY Electrical Advice area at ElectriciansForums.net
Reply to Need help installing switch on belt sander. in the DIY Electrical Advice area at ElectriciansForums.net
Similar Threads
Hi everyone,
after temporary removing a Sonoff that I've installed years ago to do some painting, I'm unable to get everything back to work. I've...
Hi All,
I am looking to install a Quinetic double gang in line receiver switch (QURS2W) in my hallway on the ground floor to control the lights...
Hi, I have received conflicting advice about Main Isolator Switches and would appreciate forum member's help to plan a way ahead. Looking to the...
Hi everyone :) my first post here. Quick background I'm a newly qualified installer of somewhat advanced years whose just starting out in the...
Hi all,
I'm about to replace our kitchen and one of the upgrades is to install two full size ovens to replace the original twin over under...
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.