Discuss Traying a swa round a corner in the UK Electrical Forum area at ElectriciansForums.net
No just where it starts to bend.Can’t tell from the photo.
Is the tray to the left stood off from the wall with 3 layers of Uni as well?
Ha haCoat it in factor 50 sun cream.
How about drilling a large hole through the wall and feeding the cable through?Must admit I would have had the bricks out, set the cable through and then rebrick it into the wall.
I agree but others didntMust admit I would have had the bricks out, set the cable through and then rebrick it into the wall.
Exactly thanks for thatI would change those tie raps for metal the plastic ones will go brittle , not a bad job though its always easy afterwoulds to think of a beter way of doing it , may be swan neck to tray back closer to the wall next time
ThanksCan't understand why to keep it uniform the tray wasn't taken away from the wall pre bend then you go around the bend and take it back so it matches both sides.
Bit of a bodge methinks.........
And the radius isn't uniform around the bend, tsk, when I where a lad.............
Reply to Traying a swa round a corner in the UK Electrical Forum area at ElectriciansForums.net