holder

Recent contents Top users
  1. S

    2 gang light switch with fuse holder

    i need to replace a 2 gang light switch but its got a fuse holder next to the switches with a plug top fuse in. its not in a grid format just a normal 2 gang switch on a single plate with the fuse older. any one know where i can get one from?
  2. L

    Pulling Main Fuse

    Hi All, Obviously I have never pull the main fuse, but out of interest does anyone know where you can get the saftey inserts from... the orange/red ones the meter guys/DNO carry to 'plug' the hole whilst the fuse is pulled... Any links etc would be good........ just for reference obviously...
  3. R

    Mermera 30A HRC fuse carrier and holder

    Morning gents and lasses, A very long shot, but does anyone happen to have one knocking around that I could purchase? All the ebay ones seem to be missing bits ect Thank you
  4. S

    Switch Wiring Assistance

    Hi, could someone help me out with wiring up a switch please. We have a very dark cupboard below the stairs, and I want to install a light that will come on when the cupboard door is opened. I was planning on plugging a cable into a nearby wall socket, and running that into the cupboard to...
  5. C

    Fuse holder for plug top fuse

    Hi All, I need to get hold of an in-line fuse holder that will take 3amp plug-top fuses - anyone got any idea where i can get these from??
    • chloebear
    • Thread
    • fuse fuses holder plug something
    • Replies: 11
    • Forum: UK Electrical Forum
  6. L

    Anybody seen a fault like this?

    Evening Fella's Bit of a strange fault, can anybody point me to the cause of it? 3 SELV downlights which I have installed in a bathroom about a year ago, fittings are JCC with sylvania 12v lamps & Halolite loop in/out tranny's, wired in 1.5mm & all three fittings spidered from a wiring centre...
    • LlandrilloSpark
    • Thread
    • anybody fault fittings holder still wiring
    • Replies: 18
    • Forum: UK Electrical Forum
  7. spark-ticus

    Voltage YES illumination NO.....!!!!????

    My lords, ladies and gentlemen, I was asked to look at some outside lights for a customer, they are in his garden (palstic spike type) they are 240v and have been installed by a very definate john wayne (connector block wrapped in insulation tape and burried!) i have put the connections into ip...
  8. P

    FCU fault?

    Hi all have any of you ever come across a problem where the fuse carrier of a fused connection unit has popped out on its own leaving the 3 amp fuse undamaged? I went to a house this morning to investigate what seems to be a different issue not related to this fcu problem, but apparently this...
  9. L

    fluke 165x battery holder

    hi guys, if anyone has an old fluke they dont use anymore or does not work I am after just the battery holder that houses the 6 AA batteries in the bottom. I have tried fluke and although only £18 they give a 3-4 week wait time. I am willing to pay handsomely for said part. Many Thanks.
  10. sjhall

    Core drill recommendations

    Any of you lads use a dedicated core drill? Any recommendations ? Been looking at the Bosch gdb1600 so far. Cheers
  11. A

    Cable reel holder

    Decided to build my own cable reel holder :rolleyes4: , Thought this would be a great Idea and save me a fortune, turns out the parts have cost me £25 so probably could have brought a proper one !!!!, buy hey ho nothing ventured nothing gained will post some pics when done.
  12. Tuttle

    Company position for sole trader

    As a sole trader, what is my position in my "company"? E.g. for test certificates and other general forms / documentation? What's generally used in this situation?
    • Tuttle
    • Thread
    • company holder inspector position trade trader
    • Replies: 8
    • Forum: Business Related
  13. L

    Put lamp in holder and the power dies... WHY?

    Hi all. So called out to a domestic properety as light fell off ceiling. Put it back together and power all shows good. L/E, L/N power 230v no reading N/E. But no power when connected to fitting? So swapped fitting for 6" pendant and did same? So took the lamp out of pendant and power readings...
    • Ladders
    • Thread
    • aus holder lamp lighting lights power
    • Replies: 31
    • Forum: Australia
  14. P

    R63 White Downer (spot fitting lamp holder)

    Hi I have an usual property with wooden eaves. In these I have outdoor lighting with about 10 R63 white bulbs in a plastic unit that has plastic arms that keeps it in place. The colour of these are white. I have searched everywhere but just cannot find a replacement. Any tips on where to...
    • pin145
    • Thread
    • aus fitting holder lamp lamp holder lighting lights white
    • Replies: 5
    • Forum: Australia
  15. E

    Screwdriver Bits & Boxes (Dewalt & Wera)

    Hi Guys, just been clearing out my van and have far too many spares of things so here they are. 4x Dewalt Heavy duty organiser boxes 1 x Dewalt HSS Bit Set in Case 1 x Wera Rapidator PZ2 set with holder and bits Approx 100 Dewalt & Wera Bits (Slotted, PZ, PH, Torx etc Wera Kraftform Kompakt 40...
  16. K

    bathroom type bulb holder

    Hi I am looking to purchase the type of bulb holder that comes with conventional bathroom light fittings that aligns the bulb horizontally with the ceiling rather than vertically as with a pendant fitting. I need these for use with separately purchased lamp shades that fit close to the ceiling...
    • kevvyb
    • Thread
    • aus bathroom bulb holder type
    • Replies: 2
    • Forum: Australia
  17. S

    wiha bit holder

    anyone got the above or know where to one , links would be a great help, i did find a supplier in the us but require a minimum order which obviously i dont want, thanks
  18. S

    Waterproof in-line 3amp fuse holder for domestic wiring - does it exist?

    Hi all, I have been looking high and low for a waterproof 3amp in-line fuse holder, with no success. I am beginning to wonder if they exist. Perhaps they're under a different name? I need to power a 3amp bathroom fan from a 13amp power socket. The fuse can't be changed on the power socket due...
    • Spiritseeker
    • Thread
    • 3amp aus domestic fuse holder waterproof wiring
    • Replies: 13
    • Forum: Australia
  19. Kamikaze

    Tax Disc Holder

    Land Rover Introduce the Self-Levelling Tax Disc Holder ;) http://www.youtube.com/watch?v=ImSlgHaGU6k Happy April fools day....lol :D
  20. E

    is £40 callout charge too cheap for domestic house holder??

    the new year is here and every thing is going up in price. are you all putting your prices up to?? ive been charging people £40 for the first half hour then 20-30ph after that. i get good bit of work charging like his but have the feeling call out is on the cheap side. recently people...
    • egginyourface
    • Thread
    • aus charge cheap domestic first holder hours house london too
    • Replies: 25
    • Forum: Australia

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Electricians' Talk
Plumbing Advice
Tilers Talk
Plumbers Forum - Plumbing Advice
UK Tiling News
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock