What is the maximum length you can have of Schuco rail before you need a sliding rather than a fixed rail connector? I am sure I have seen it before in one of the manuals but cannot find it now. Thanks
Regards
Bruce
Hi all
could someone please be so kind to explain how i work out the length of a existing ring final circuit 2.5/1.5 T/E
and in turn Volt Drop
i know to work out length its L= R x 1000 divided by m/ohm/m but would i use the r1 measurement eg 0.58ohms
rn was 0.58ohms
r2 was 0.96
or from the...
Hello,
We have had a log cabin for my better half to run her company from. All wired ect, but she now needs a BT point for a Card machine.
As the crow flys it's about 35 - 40 meters from the master, which is the only point in the property.
Is there a maximum distance specified by BT after...
Hi I have a query one of you may know the answer to. I have installed some lights in the woodlands for a customer and he is using 12watt LED lights he is only installing a few i think it was 186 watts or something. I have used SWA cable 1.5 mm as it is about 200metres and worked out the...
switched on
Thread
aus
cable
circuit
length
lights
supply
volt drop
volts
I've noticed a number of threads regarding exam questions asking to calculate the length of a cable by measuring resistance. But I can't think of a practical situation where you would ever need to do this and seriously doubt the accuracy of the method. I know there are specialist cable fault...
Hi Peeps
I have my 2391 coming up in October and I am busy revising.
When determing the circuit length and VD, my notes say to link L - N at the load side and take the loop resistance at the DB.
The example I have is : Loop Resistance = 0.7 ohms (R) and csa of cable = 1mm2 (S), calculate the...
hi guys
after a little advice re a 30 A Type 2 BS 3871 MCB. Now i know they are old but still compliant , just checked the OSG p 49 Table 7.1 for maximum length and installation methods but there not listed.
i have the maximum ZS of 0.88 from page 103 table 2d OSG where they are listed.
can...
Hi,
Im working on site in worthing and have been asked to find out the length of an installed cable.
Cable size 150mm 4 core
r1+r1=0.3
Ze=0.06
Any help on how to calculate the length of cable would be much appreciated.
hi there guy's i have to move a consumer unit from the understair's cupboard,to the larder cupboard,which back's onto the wall,where the original consumer unit sit's,the problem i have is i can't remember the maximum length the 25mm tail's you are allowed to have, without installing a separate...
Hi
I am considering the possibility of using 2 unused and existing 95mm 4core aluminium cables in parallel to feed a new submain distribution board I wondered if any one else has done similar and may be able to reassure me on the practical and/or technical implications the length of run is 130m...
Chaps,
I notice the Schuco Rail length calculation is "22 mm + [number of modules x (module
width + 21 mm)]".
I'm guessing this leaves zero gap at the end of the rail after the end-clamps.
Are Schuco expecting their end-clamps to be flush with the end of the rail then?
Hi
Taking a spur off a socket into a 13A FCU then out to a garden socket about 20m away.
Do the rules of cable length still apply as i'm using a fcu or do i have to measure the downstairs ring and make sure it doesn.t exeed 106m in 2.5 for the whole ring.
Or shall i just check the voltage drop...
Hi guys,
Does anyone know where I might be able to get hold of some reinforced burglar alarm cable? It's to be run from the main house control panel to a shed in the garden.
is this correct for lighting circuit of 1.5mm line and 1mm cpc
ze+R1+R2=zs
b6 mcb ze R1+R2
6.18ohms - 0.8ohms =5.38ohms
cable per meter = 0.03020ohms so 5.38ohms/0.03020=178.1M
does this mean my lighting circuit can be this length 178M and still be within zs...
Putting a final ring in kitchen and will have a fcu on the ring for the cooker hood.
I want to then run from fcu up wall to a flex plate.
Due a window above the fcu I can't run straight up and it also wouldn't be where the outlet needs to be. I can run down from the fcu, under the floor...
I've seen many cheap(£1.49) 4 way 0.5 metre extensions on sale in Asda and Morrisons. I seem to remember from somewhere that an extension lead has to be at least 1 metre long. Occasionaly, the short cable allows easy placement for audio etc. but I thought it wasn't allowed. Does anyone else...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.