strange

  1. S

    Strange N-E fault on armoured cable supply to sub-main

    I've installed a garage consumer unit sub-main to an outbuilding in 16mm 3 core armoured, the insulation tests all come back fine - +800Mohms on a 500 volt test but when I power up the installation I get 90 volts leaking to Earth from Neutral and i'm not sure why. The Garage RCD also doesn't...
  2. littlespark

    Strange things in the post. Possible hoax or con?

    As the title suggests, we've had a number of letters to an individual addressed to our home, but who doesn't live here... and has never lived here. We've owned the house since it was built. Normally we send the letters back into the post with "not known at this address" written on it... but...
  3. L

    Strange or old

    In my house the lighting circuit is made up of One live and earth in same sheathing. Then 2 separate neutrals. I haven’t seen this arrangement before and I’m wondering what this is.
  4. A

    Help needed, is this correct?

    I have a two 32mcb in the c/u. I thought one would be for the upstairs sockets and one would be for the downstairs sockets but they are not. both require switching off to cut off power off to both upstairs and downstairs sockets!! is something wrong with this? each 32mcb has only one live...
  5. M

    Electric knife: strange wiring: request advice

    The knife is Russell-Hobbs, ECO1255, model 13892. I work for a charity which receives (among other things) electrical goods which must be tested before we can give them to recipients. The PAT meter gave weird results: normally when the device being tested is switched off the meter says "lo...
  6. Matt

    Strange "pellets" in the loft.

    Hey, I am very new to the trade and I was helping a mate on a house rewire the other day and I found something that intrigued me. When I went up into the loft I found loads if these: Does anybody know what these are? the loft floor is littered with loads of them. The house is really old, if...
  7. G

    Strange problem with PIR/motion sensor switch

    Hi, I have an odd problem with a motion sensor switch in a bathroom. The sensor detects motion and switches the light on, but then doesn't switch the light off. However, when I switch the fuse off and then on again at the fusebox, it resets the motion sensor, which works fine, but only once -...
  8. J

    Strange design of Induction Hob power input, advice please

    Hi, hope everyone is enjoying Easter! I have boon looking for an induction hob recently and found one on ebay for £25 and close by so I bought it, yay!. It was purchased as defective, its a 5 sone hob and the two left zones did not power up. A bit of research before purchase shows there were...
  9. Smanna

    Strange wire colours

    i want to attach a new light to the ceiling but the wires are old. There is a red wire, a brown wire and what seems like a black one. I dared not get them mixed up as I don't want to blow anything up. Can anyone advise on how to proceed and figure out which wire is which? Thanks
  10. M

    air bag light comes on at strange times

    My niece has a 2004 Mazda Tribute with a strange air bag light problem. She can make a 40 mile round trip without the light coming on if there are no high load devices on, but if she turns on the heater or lights the air bag light comes on a few seconds later. To me this means the problem is due...
  11. G

    Strange Fault on a Farm!

    Hi Guys I am new to the Forum so here goes...... We have been called to a Farm which is 40+ years old, it is a TT 3 phase supply and has a 100mA main RCD switch at the incoming supply. There is a main DB in the barn and out of that is an SWA sub main which feeds a stable with only one...
  12. W

    Strange buzz/chirp noise coming from anything plugged in

    Hi, recently I noticed a repeating static kind of sound (here's a recording, its kind of quiet - Vocaroo | Voice message - https://vocaroo.com/i/s1BmtSek9HLs) coming from the power supplies of pretty much anything plugged in in my flat. (first noticed in my computer, then my monitor, charging...
  13. LewisM

    Strange issue with drill

    Hi, my drill bushes burnt out and I've changed them but now when I fully tighten the case the drill doesn't work at all, but when the case is loose the drill works fine. Any ideas Drill is Hitachi DV18DSDL Thanks Lewis
  14. M

    Strange Earth Leakage Trips

    I have an odd situation in that I get random earth leakage trips which happen occasionally when I turn off an outside light. I have a standard split board, half earth leakage protected, half not. Trips happen maybe once every 50 times that outside light is switched off, never when it is...
  15. gazdkw82

    Strange voltage readings - broken earth

    Was fixing a broken twin florescent fitting today and came across something I couldn't work out. First thing I did was measure the incoming voltage. At the fitting I measured L-E =190, N-E = 90v. Scratched my head for a minute until I realized the Earth's coming in from the numerous (4) twin...
  16. J

    Strange 2-way wiring

    Came across some bizarre wiring for a 2-way recently in a old house. Anyone ever seen this before? Was this ever the done thing many moons ago? (Sorry for the rough sketch)
  17. J

    Strange fault, can’t work it out

    hi there, first post. I’m having a very strange problem affecting my entire board. I’ve just qualified but not that experienced in faults. My home electrics have been having problems lately, every time we use the kettle/ toaster/ hairdryer, the lights dim. If we have the toaster on and use...
  18. Dave OCD

    Very strange this one.

    This is true - I called in to see a customer who'd reported that every time his wife went upstairs for a shower in the evening the telly in the lounge would lose reception - particularly BBC1 ! :confused: I established that it was the bathroom lights being switched on that caused the issue and...
  19. R

    Strange RCD tripping scenario

    Any suggestions as to possible causes of RCD tripping in the below domestic scenario would be helpful: Origin: single phase TT supply into an external cabinet housing cutout and our installed 100A 100mA Type S 2Pole RCD. Earth Rod has also been sunk here. House: 3c SWA supply to house from...
  20. bigspark17

    Strange outbuilding/pv set up.....

    Went to see a job where pv pannels have been installed on a large outbuilding, 10mm 3c swa sub ran in to pv isolator/inverter set up, submain supplied off 32A mcb. Seems ok, but the installers left what was already feeding the outbuilding an old 10mm t&e overhead which is now laying on the...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock