Discuss are cables with 240 volts allowed to be clipped direct in zone 1 of bathroom in the Australia area at ElectriciansForums.net

M

Mike Watters

the periodic report reports cables clipped direct in zone 1 illegal. cables supply a water heater and a wall heater. thanks in advance. the cables run lower than the 2.5 meters allowed in zone one
 
the periodic report reports cables clipped direct in zone 1 illegal. cables supply a water heater and a wall heater. thanks in advance. the cables run lower than the 2.5 meters allowed in zone one

Far from an ideal setup, what kind of bathroom is this, Reg wise, it really does focus on equipment, switchgear and accessories but cant say for definate there is not one there but not something i have come accross, last thing i would want to share my shower with is a cable, what if rubber ducky damaged it!!

In hindsight, i would say get it in some decent containment outside the zone, sounds like it looks like a pigsear anyway so anything would look better and of course comply
 
Last edited:
Yes they can be clipped direct.
The 16th had a requirement that cables could cross a higher number zone to reach equipment in a lower numbered zone, but not the other way around.
Obviously the cables are required to be suitable for the environment they are in.
 
As Spin has said, yes it's OK but assumes that the cable itself is intact and robust, with the main environmental effects of heat and moisture having been taken into account.

If someone has flagged it on a report as a failure just because it's there, then they need to go back to Sparky school.
 
It may have been coded because the vertical runs terminate inside the equipment or accessory without the use of cable glands, sealed entry or drip loops, thus allowing condensation to run down the cable and directly into the equipment or accessory.
 

Reply to are cables with 240 volts allowed to be clipped direct in zone 1 of bathroom in the Australia area at ElectriciansForums.net

Similar Threads

Hi, I have a Victron Multiplus-II 5kVA inverter/charger with Pylontech US5000 batteries installed in my house along with a 6.8kWp PV array and...
Replies
12
Views
501
Hi All, I have a client who is developing a plot of land for a single house. Currently, their 100 amp service cut-out is in a cubicle fed by...
Replies
7
Views
1K
Just taken deilvery of an Electric Car (Mini Electric) and so doing some research into installing a charge point. Supply is a standard Single...
Replies
10
Views
4K
I’m running wires to the basement for future basement finishing. I’d like to add two circuits of outlets (one on the finished side and one on the...
Replies
1
Views
685
Hi, I'd be very grateful if anyone could help me here. Below, I've pasted a sketch showing how my oven is currently wired up, followed by 3...
Replies
0
Views
944

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock