Hi guys
I've a practical test soon for work as a smart meter installer
Looking for any tips on working with 16/25 stranded singles .Could be a mix of pvc only and sheathed, 7 strand
Im going to make a dummy board and practice moving things around and connecting to improve my profiency
Any...
I have a customer who has installed a second empty meter cabinet for a consumer unit to feed several garden circuits. Can a standard metal csu be fitted in here, does it have to be in an ip65 enclosure also or can a ip65 plastic csu be used.
I get csu has to be non combustible within a dwelling...
I have just had a "smart" meter installed , and at night the electrics trips the RCD when the night storage radiator section comes on. I have had them out and they said installation was correct. I know a little about electrics (more over cautious and basic) but was suppressed when I looked at...
Hi, gone to look at a board change job, it’s an old re-wirable fuse box less than 3m away from DNO and ran in 16mm tails, 10mm earth and no bonding to the incoming gas pipe and customer has no idea where the water comes in as the house has no stop cock. I will be putting a dual split rcd 100a...
I'm a homeowner. My flat came with a prepayment meter.
I was due to get it changed by Green Network Energy. I even specifically chose them because they would fit a standard meter and not a smart meter...
Anyway, Covid and a company going bust later I still have a prepayment meter.
I'm with...
I've had an electrician out to my house as I wanted him to remove the trunking that went down from the consumer unit down of the inside wall and then across the outside wall where it threaded through to the meter on the outside.
The electrician said he could chase out the wall so wiring from...
I am a builder who is renovating a rural property. A smart meter is due to be installed. It would IMHO be a good idea to get a rec switch installed. What can I expect the meter installers to do ? There is just about enough space for a slimline rec switch / isolator. to the right of...
I am trying to move into a house that has been vacant for 2 years. I called the power company because the power isn't working. They sent someone out, but said the meter is good and we need to hire a electrician.
The electrician came out and used a device to see if power was coming out. It...
Today I got a note by postcard from SSE saying:
"We recently contacted you about your new smart meter, which can be delivered and installed for you from 10 May"
Now I am not aware of being contacted, certainly not by phone, so it seems a bit disingenuous to tell me this. Also I have a fairly...
Hi,
I just had a new 18th gen with surge protection installed. They disconnected the old cable and did a new run, the cert says 10 gauge was used but then I just had a different sparky who is looking to wire up my garage see it and say it should be 16.
Just wondering what is correct and should...
An interesting phone conversation with my own electricity supplier (Good Energy) which was very disappointing, and made me sigh (professionally) :(
They phoned out of the blue to ask if they could book a date to replace my gas and electricity meters with smart versions. I said I'd probably be...
Our solar system was installed 8 years ago. We had no problems until EON replaced our smart meter, and our electricity and gas meters with it. Since then, our PV generation meter has gone mad. Running all day and all night, to the extent that British Gas refused to pay our FIT, because of the...
Property missing meter box door for an external box that isn't recessed. It's an unusual size (to my eyes) 555mm high by 365mm wide. I can't seem to find a door anywhere including ebay!
I've used an over box for a recessed one before but this isn't flush mounted.
Any thought's welcomed that are...
Hi, I need to install a digital coin meter for a small flat in a common area of the main property. There is no room in the meter cupboard so have identified an area directly above the cupboard to site it. I had in mind the standard GRP surface mounted meter boxes, but they are a bit large for...
So, I've had one of those days of chasing my tail...
What should have been a simple hour's job of fitting a 3ph CT consumption meter.....
no / little load = fine, behaves as expected.
load (ashp compressors) = meter claims incorrect polarities, meter claims it's generating... much weirdness...
Hi, rhis has probably been done to death, but I couldn't find much on a search...
Doing a garage conversion. CU recently replaced at ceilling height. New 25mm tails + earth currently run vertically up wall in 50x50 maxi trunking. Was hoping we'd be ok to leave and just plasterboard up to sides...
Need to retro-fit a simple KWH meter onto a 63/3ph circuit, space restrictions mean it'll have to be a separate meter with ct coils. I've been looking online but nothing much is grabbing my attention in the cost/quality (reliable but not £££'s) department. Anyone have any recommendations?
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.