Hi just carried out an EICR prior to a consumer unit change. The customer has a wet room with a normal baton type accessorie. The ceiling height is more than 2.25 mtrs but the shower head is less than 1.2 meters from the light in a straight line. There is no rcd at the minute but will be once...
Completed a job about a month ago on a small extension. They created a downstairs toilet and shower which is L shaped. On the architects plans it showed a 700sq shower tray and enclosure.
So to describe it, you open the door and I have put light switch just inside. 3M and it turns and 3m...
hi guys,
just a quick one, what zones can you fit a pull switch in a bathroom?
i have to fit a shower-light-fan combo above a bath that has a shower in it, can i fit the pull switch in the ceiling above the bath at the opposite end to the shower? This way it makes it obvious that the pull...
can someone confirm if i have read the regs correctly. if a light fitting is 0.6m away from a bath it is outside the zones so it could be a pendant fitting if you wanted one.
Thanks
Hi
Basically, I've just finished the 1st fix on a property, customer and builder wanted CU to go into kitchen cupboard where the gas meter was. Gas meter has been disconnected, builder waiting on National Grid to come and re-site gas meter externally.
National Grid came out on Friday, customer...
I was completing my current job on Friday and whilst I was there the Virgin installer turned up to route a cable into the new extension. He asked the home owner where she wanted it to enter the room and then asked if she knew where the electrical cables were routed? He was pointed in my...
Evening all,
Tomorrow i've got to 2nd fix a combi boiler with 2 heating zones and hot water, but i haven't really done many heating systems!
So is there a certain plan(s plan, Yplan etc ) to connect it all together.
Any help appreciated
chris
As the title says. The shaver socket has been 1st fixed on the right hand side of the wash basin, but due to the close proximity of the bath, the shaver socket falls just inside the edge of the bath.Wil this need to be moved? If so how far?
All,
I'm having a really blonde moment. Would one of you good people remind me what the safe zones are "around" a CU??
I'm thinking they are the same as "any" accessory - i.e. vertical and horizontal but somebody else says no!
Thanks
ok guys page 202 in BGB illustration (c), if there was a fixed shower head close to the 2.25m zone limit whats the score with a recessed ceiling light? how close can you have the shower head to luminaire?
only ask as i saw this round a friends house recently.
cheers
Just been to an inspection today, as with many of them its suffering from a bit of DIY, bathroom downlights are above 225, so are out of zones, but are not IP rated, so I will probably give them a C3 ? They are double insulated but the earths have been nicely snipped out so are discontinuous &...
andyyoyo
Thread
again
codes
double
eicr
fittings
maybe
protection
rated
zones
Hi all I am wiring a boiler system up with 4 zones, under floor heating (with manifold actuators and own wiring centre poly pipe), heating up, heating down and hot water.Am I right in thinking that I can wire each zone as usual and link the switch live through each zone back to boiler?Thanks in...
Hi Everyone
I'm look for a customer who wants switching in his bathroom via plate switches INSIDE the bathroom - no to pull switches and no to switches outside the room. He is out of zones. I can't find a moisture resistant plate switch that does not look external. Have you used one before?
TIA...
Hey my learned friends.
could anyone point me in the right direction of a regulation that would go against putting a shower isolator near the mains and not in or just outside the bathroom.. Is there a reg or is it just good working practice?
ive looked at this thread but I need regs...
Edd
Thread
aus
electrical
isolator
marked
outside
shower
zones
I've got a customer that wants a supply to an electric cooker installed with the cooker switch fitted under the work surface accessible through a cupboard. The obvious way to route the cable is horizontally across the kitchen wall to the cooker switch. I think that this is allowed as this is in...
Hi
Customer has bought a metal wall lamp for use in their ensuite. Its more than 0.6m from the shower cubicle and the circuit has 30ma RCD protection. Im not a fan of non bathroom lights in a bathroom but would you fit it?
Thanks in advance guys.
Kind Regards, David
Hi all, First fixed refurbished kitchen in old property, stripped out old wiring, ran in new ring main to kitchen and cooker circuit. Really awkward cable runs due to new steel RSJ across width of kitchen, and no access from 2nd floor. All cables run in 17th edition 'safe zones' , problem comes...
Hi all, after a bit of advice. I have carried out a C/U change and of course a full test and inspection of the installation. In the bathroom there is a spur which is approx 2.4m from floor, but in line with the edge of the bath. It used to be for a heater but a plumber has now re-used the spur...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.