Hell all,
I have bought and installed a LS400 Intruder Alarm. On testing I have found that when set in the Away Mode, and excluding entry/exit zone/route the following:
If the alarm is activated there is a 15 second delay before the internal sounder operates and a further 30 second delay...
birchall101
Thread
alarm
before
delay
intruder
second
sounder
time
time delay
zones
Got a call from a letting company concerning an extractor fan in a bathroom.
Unswitched spur and 230v extractor fan with timer (IPX4) fitted directly above the shower, wall mounted, the centre of the fan is 220cm from shower tray level, therefore in zone 1.
The spur is above the fan and is...
Are gas pipes allowed to be chased into a block wall and plastered over in a domestic property?
I have been looking in the 'Safety in the installation and use of gas systems and appliances regulations' but cannot find anything that says it can't.
I'm chasing out a tiny kitchen in a studio flat & my boss wants me to do a chase down to every box which is 8 drops. There's a stud wall on the one side I could use. My question is, he said I can't go horizontally. I said you can, if its in line with a box. Whose right?
I’m looking for some advice on VERITAS 8 alarm panels. I want to add 3 additional zones and remote key pad in my garage, but only have a standard key pad (no display) which looking at the instructions/manual could be a very long winded way of programming the new zones regarding parts sets etc...
nash
Thread
additional
better
circuit
circuits
key
keypad
remote
texecom
veritas
zones
Hi all
i have been asked to look at an install for a plumber friend which incorporates 3 zone valves including one for ufh, I'm ok with wiring everything (s-plan) apart from the ufh it's in 2 zones and has 2 stats and its own wiring centre.The stats are 24v,how are these wired to the zone valve...
If I fit a fixed shower head flush with the ceiling, like this one:
Would that make Zone 1 include the ceiling, the walls up to the ceiling or would zone 1 still finish at 2.25m? Ceiling height is 2.4m. Wondering whether I will need zone 1 lighting & vents in the ceiling.
Hi,
been a lurker on this forum for a long time, but this is my first post, doing some electriclal work which i will be using for my niceic assessment, need to run main protective bonding to the gas meter which is in a unit underneath the kitchen sink, the only way I can see is to chase in by...
Just a quick question, in the general section of this form,
1. presence of under voltage protective devices, there are passive rcds on the cu and no dol starter, I've put n/a for this
2. Connection of single pole devices for protection or switching in line conductors only, all sockets used...
my mate as rang me up as he is having a new kitchen fitted by b&q, they are doing the full lot electrics as well, they are putting 2 new feeds in 1 for the built in oven and 1 for the combination microwave, the house is only about 5 years old and they said they are going to have run 2 x 2.5 t&e...
Need to find out where someone routed cables in 1970's extension so I can part the light circuit from the ring!!!
Any ideas what tools are best to trace the cables?
The extension is a flat roof that 3 months ago was replaced, typical!
Have been looking at fuse finders, tone generators, multi...
I am compiling an EICR on a period style house with wiring dating back to mid 60's. The installation has a fuseboard with 3036 fuses protecting all circuits. The bathroom has neither RCD protection or evident supplementary bonding arrangements although there is a 10mm bond to the main water...
Quoted a job today one room RFC sockets have been specified by client at 700mm up wall due to partiall sightedness now before i get the book out am I right in saying that a direct line between sockets on the horizontal and from the centre vertical is taken as a safe or prescibed zone
Pict
Hi all,
I have had a QUICK look in the regs book and it seems that kitchens are not covered under the special locations and zoned locations.
At college our lecturer said the zones only apply to basins that you can submerge yourself in water - e.g baths and shower basins (and of course swimming...
ed-ectrician
Thread
building
installation
installations
kitchen
other
socket
sockets
zones
hi ..i recently had to rough out lighting in a 2 bedroom flat ..flat was orig wired in lead covered cable..flat also has flagstone floors in all except 1 rm and nice cornice in most rms..when i wired flat i ran all cables behind skirtings and facings as original ( i no 150mm from ceiling is...
Guys, I need to settle an argument with a colleague with the location of a towel rail spur....
As per table and fig 8.1 in the OSG, switched fuse spur can be installed for a towel rail outside of the zones...?
I understand sockets need to be 3m from the bath or shower, to allow for the...
screech
Thread
bathroom
don't
outside
shower
spur
switch
switched
zones
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.