enclosure

Recent contents Top users
  1. D

    RCD for TT system

    Hi all, I have just read an old periodic report that has highlighted a TT system that has an RCD main switch mounted in a non insulated enclosure (metal) as a category 2. Does it state anywhere in the reg that the RCD should be in an insulated (plastic) enclosure. I've had a look but cant find...
  2. B

    Lockable/Vandal proof fused spurs

    Hi I need some unstitched fused spurs that are to be insalled in a challenging location that has a history of misuse and vandalism. Has anyone come across any spurs that the fuse cannot be easily removed or a lockable enclosure to fit a sput into. many thanks,
    • benieb
    • Thread
    • compliant electricians vans enclosure fuse fused metal proof really scrap spurs van vehicle
    • Replies: 18
    • Forum: UK Electrical Forum
  3. R

    IP66 Enclosure

    I want to install a cooler unit of Rittal make on one side of an enclosure of IP66 rating. I need to cut suitable holes to the enclosure to do this. What should I do to keep the IP rating of the whole assembly?
  4. DaveyD

    SPST Relay 230v and enclosure

    Hi Can anyone advise where I can get a 230v SPST relay with screw connectors and an enclosure? I need for UFH. Thank you in advance. Regards, David
  5. A

    Connectors on lighting circuits

    Hi all hope you can help came across a rewire were all the down lighters have been wired up with strip connectors is this acceptable under BS7671 and dose this comply as an enclosure reg 5265 good advise please
    • AA410
    • Thread
    • circuit circuits connectors customer enclosure lighting strip
    • Replies: 50
    • Forum: UK Electrical Forum
  6. M

    Garage enclosure

    Hi all, Rewired my dads garage today for my part p assessment, i bought an enclosure and a 16amp and 6 amp mcbs for the circuits within the garage. The enclosure only had the din rail in. No earth or neutral bars. The garage is fed from a 32amp mcb from the cu in the house by 2.5 mm cable which...
  7. U

    RCD after meter & before CU

    Basically old cu not enough space for rcd inside unit but meter and unit is inside cupboard. Could an rcd be placed before the main switch on a din rail? Would this conform to have it exposed in a cupboard inbetweeb meter and unit. Ideally a board would be replaced but due to time and money...
  8. I

    light fitting with choc block enclosure

    most new light fitings now seem to come with the connector block within a square enclosure or choc block. Had to fit a replacement bathroom light yesterday circular bulkhead (g9 bulb). there did not appear to be enough room for the choc block to fit. i removed the choc block and fitted wago...
  9. kingeri

    Multiple circuits in one enclosure

    So I am at a job right now to fit downlights in a bathroom (I tried to talk her out of it), and have easy access via loft above. Isolated upstairs lighting circuit. Wiring in loft is very neat, there is a Line enclosure present, all cables neatly clipped. However, on inspection I have found...
  10. W

    2 Module Enclosure

    On the front cover of May 2012 Professional Electrician shows a rather tidy 2 Mod Enclosure. Does anyone know what make they are and or who sells them? Thanks.
  11. E

    large junction box or enclosure wanted

    i've got to replace a board, it's in a stupid location (behind a garage door frame) and wants moved about 4 foot to the left. half of the circuits come throught the back of the board along with the tails and the other half are clipped to the black wall and go up. ideally i want an enclosure...
  12. S

    Single enclosure for RCBO needed!!!!

    I'm looking for a single enclosure that will hold an RCBO. Every one that my local supplier have are only big enough for an MCB! Anybody suggest a make or site where would be best to get this?
    • SSE
    • Thread
    • anybody earth enclosure fault needed rcbo rcbo's single voltage
    • Replies: 11
    • Forum: UK Electrical Forum
  13. T

    whats the best enclosure

    pic showsa trench in between old and new doorway under stairs.i want to run some twin and earth between the opening to sockets either side. using this job to join elecsa so wondered what i could get away with? am i looking at galv conduit? could i put a wooden board over the top? pvc conduit or...
  14. A

    Earth bar melting CU enclosure!

    A friend rang me today to ask if I could come and look at his melting CU. He said that all the circuits were holding and everything operating correctly, he only noticed something was wrong when he saw smoke coming from under the stairs!! His land lord sent round a 'Multi trade' lad to 'fix' it...
  15. T

    Enclosure Cabinets (GRP)

    I'm manufacturing modern enclosure cabinets intended for domestic and industrial use, can be installed outside and inside the buildings. My cabinets are made of GRP (glass fibre reinforced polyester) which doesn't corrode, is non-flammable and very easy to assemble, has an aesthetic appearance...
  16. O

    EICR Coding Opinions please

    Ok, so here I am testing/inspecting some new floodlights installed at a local community facility. The installers, in their wisdom scarpered without leaving anything resembling a certificate so I'm doing a EICR on the 2 circuits in question. The "post" end of the circuits is shown here, there is...
  17. D

    Insulated 3 Phase DB...?

    any body come accross insulated 3 phase db??? got a TT install and ideally a 24W TPN DB converted to single phase will be ideal rather than a 21 Way box....!!
    • DurhamSparky
    • Thread
    • 3 phase boards enclosure insulated merlin phase
    • Replies: 6
    • Forum: UK Electrical Forum
  18. Mark42

    12V Bell supply & mains relay in one enclosure: Does it comply?

    A 24Vdc door bell supply, provided by a transformer and relay near the main DB. Various bell-pushes and 24V bells around the site. All in mains-rated cable and often run together with mains looms. The original bell in my workshop was not audible when machinery is running. Single bell replaced...
  19. D

    rcbo tripping.

    12345678
    • dragon90
    • Thread
    • aus enclosure fault rcbo tripping wiring
    • Replies: 6
    • Forum: Australia
  20. N

    Security mesh cage for wall mounted inverter

    Does anyone have any contacts for a reasonably priced security cage or enclosure for an external wall mounted inverter ? Our client is located in an area where they are worried about theft and/or vandalism? Thanks

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Contractor Advice Forum
TilersForums.co.uk
TilersForums.co.uk | UK Tiling Forum - Est 2006
Tile Forum
Tiling Blog
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock