Hall of Shame Photos

[somersetsparks]

(also, kewtech testers, which you can see in pic, worst tester i have ever used)

Aren't those kewtech testers just the good old robins rebuilt? I use robins all the time, they are pretty ancient but still going strong, I have the luxury of de-lock on my loop tester!

 

[RWJ]

Aren't those kewtech testers just the good old robins rebuilt? I use robins all the time, they are pretty ancient but still going strong, I have the luxury of de-lock on my loop tester!

Yep grey Robins well they're actually Kyoritsu

 

[BOROROBBO]

Aren't those kewtech testers just the good old robins rebuilt? I use robins all the time, they are pretty ancient but still going strong, I have the luxury of de-lock on my loop tester!

yeh as far as im aware its the same just a different name. they were good until i discovered a megger

 

[BOROROBBO]

under a floorboard

the worst thing was there was no need to do this, there was a pendant in the next bay along they could have tapped into. tut tut

 

[aptsys]

This is a light fitting that I came across that had been recently fitted by 'an electrician friend'.......

View attachment 5367

Notice the blue sleeving on the switched live, the connector blocks that are not rated for the temparature, the 'green only' sleeving to the cpc's. but best of all the way they didn't connect the cpc to the earth terminal at all and this was in a bathroom !!!

Should've looped at the switch.

 

[filo]

YIKES!!! Full use made of this henley block! Some circuits wired directly from it with no circuit protection. Wrong colours used for some meter tails, missing cpcs all over the place - the list is endless - fortunately it'll be a full rewire.

 

[Guest 004]

The famous how close to a sink can a socket outlet be? Can anyone point to an exact regulation?

no regulation, just a building reg I think

 

[RWJ]

no regulation, just a building reg I think

Correct... Building regs

The Wiring Regs just state the accessory must be fit for purpose / location etc

 

[londonlec]

YIKES!!! Full use made of this henley block! Some circuits wired directly from it with no circuit protection. Wrong colours used for some meter tails, missing cpcs all over the place - the list is endless - fortunately it'll be a full rewire.

Standard issue '951 on the incomming lead

 

[filo]

Yes, noticed that. Lots of discussion about that kind of thing - asked NICEIC inspector about it on last assessment - he said leave it alone. Asked him about requesting change to PME to overcome the problem - he reckoned TNS with 951 clamp and acceptable Ze is always preferable to PME. Who am I to disagree?