I’m working on a small office job at the moment and have to install a few twin sockets underneath a couple of desks, the desks are back to back with each other so no wall to fit the sockets to.
I’d just like to know what other people’s opinions on the best way to do this are, I’m not keen on...
Wondering if anyone has fitted eyelid type wall lights under soffits? I think I've only seen these wall mounted but I want to light up my double garage door, I want the light to point more out towards the drive than light up the door itself so wondered if this would work? Also there is a sensor...
Been a bit baffled by an issue on my mates kitchen under cabinet lights.
She has 4 lights, they are around 12 years old, the house was her mums but she inherited it, 2 work fine with no issue, the other 2 have intermittent flickering, she has replaced bulbs on a couple of occasions and still...
Hi all, quick one that I’m guessing one of you guys will solve quickly! Currently been doing some work on an old wartime building and trying to get power back onto some son floodlights after some demolition work internally, I’ve got 240v across line and neutral at the junction box (that’s...
Hi my name is Chaz based in Hounslow London. I have just recently completed my studying as a domestic installer. I know its not as good as the whole collage learning. Im 32 years of age currently working full time in a totally diffrent industry but looking for a fresh start and new career. My...
Been living in our current house for a couple of years and finally turning our spare bedroom (junk room at the moment) into a useable bedroom. I want to move a double socket a couple of feet to the left so we can fit some wardrobes in so I lifted a floorboard up today to see if it would be easy...
Hello
I am new to the forum and was hoping I could pick your collective brains.
I am an electrician with 7 years experiance. I have mainly worked for the MOD and on commercial and industrial builds throughout my time.
I now do the odd bit of domestic work and need some help on a kitchen ring...
I have a radiator mounted on the wall under the window and a socket to the right of the radiator. I have an extension running from the socket under the radiator to my desk; there is enough wire so that it runs along the floor under the radiator.
Will the wiring be dangerous due to the heat of...
Hi
I have under cabinet strip lighting. The old 2 pin lighting. I want to buy LED. Question . Can I just use the same powere cable that I used before. I have enclosed some photos . If anyone can advise , it would be much appreciated
Thanks
Steve
Hi,
I have been asked to finish a job in a shed installed 2 years ago. Just reading up on the regs, as it is heating there is an element of a higher fire risk....
What the deal if its in a wooden shed?
Hi there all. First off would just like to introduce myself real quick. My name is Martin and I live in Airdrie, Scotland!
My Wife and I have lived in our house for a little over 3 years. For the past year or so, I've been experiencing a rather odd issue (which has gotten progressively worse)...
Hi all,
I have a problem with two sets of 12V LED under cabinet lights. Set 1 is a set of 6 lights under the kitchen cabinets. Set 2 is a set of 4 lights above in glass cabinets. The problem is set 2 flicker/pulse every 20/30 seconds whilst set 1 is on and only when set 1 is on.
I have IR’d...
Hi there,
I am getting my kitchen replaced next week and I need to buy some undercabinet lighting. I prefer to have them hardwired instead of plugged-in so that we have a free socket and less cables running around.
I have found a set of dimmable puck LED lights on amazon which I like but...
Hi all been a while but need advice, done an eicr today found that the cooker switch has been left under the plinth so cable not secure etc, tested at the oven which was fine earth wise, what code would this be regarding access and cable security etc, thanks in advance
Hi
Just been to see a 3 bed new build bungalow everything's straight forward, it's just the underfloor heating I'm wary about as haven't ever wired it before, I need to speak with the plumber and ask him the spec I know, each room comes back to the manifold , the owner says the thermostat...
So...Got a call late last night client who I have done work before asked advice re builder doing electrics. Advised re CPS membership he checked on ESR builder not on there. Asked builder was he CPS member. Builder said seems best we part company client left in the lurch with no kitchen just...
Hi i hope someone has the answer to this.
Ok we have just had a new kitchen fitted and i have installed under cabinet lighting 12 volt. It is Led strip and 1 side cabinet is 1.6 meters long and the other side is 2 meters long. I have 2 power supplies 1 for each side. they are 12 volt linked to...
What yous all using for under cupboard lights , and is quick fit
Depth can only be 30mm and length 300mm and don't want to be strip light if can help it,
Thx
Morning all,
Did an EICR a couple of weeks ago and one of the things I commented on was the fact that the metal work of an undercounter fridge (the door hinge/skin mounting arrangements) did not have any continuity to the CPC of the circuit supplying it.
I can find no indication of it being a...
I am a plumber who has just come across this (sockets/spurs under bath) is this permitted?
There are 2 fused spurs and a digital shower unit under the bath. I am concerned as the bath seals have gone causing water to drip onto the fused spurs.
Has the electrics been fitted to regulation? If not...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.