Hi, I'm not an electrician or anything of the sort but I'm hoping to just get some quick advice. In moving my bed I accidentally somehow pulled the faceplate of a plug socket loose so now it's at an angle.
I won't be able to get in touch with my landlord until the morning so I'm hoping someone...
Evening all,
Just after some info on the photo attached. It’s a tn-s system with an Earth going to the cu met from under the floor boards. After lifting the boards I found the earth attached as so... I was expecting to see a clamp around the supply cable, not a choc block with legs of unknown...
Hi there everyone, first of all I would like to say what a good and helpful website this is,
I’m Huseyin, I would like to know what do I need to do to become a electrician, for example to start work immediately ?(construction site or firm).
So far Iv looked at ableskills level 2 and level 3...
hello guys
I’m after some advice please I’ve been asked to carry out some work in a children’s nursery, the scenario is as follows:-
The nursery has a kitchen which is located in a cellar (which has no window) of a large detached property, they are having a revamp of the kitchen over...
A friend who has a retail shop was concerned about her electricity consumption, I had a look and I found the supply comes from an adjoining domestic property and is fed via an isolater within the same but has had a new meter fitted by the sse again its in the other property, so I ffitted a meter...
Doing a job at the moment and the client has asked as an extra whether I can fit a second phone handset in another room from the existing. The current setup is a speaker/mike outside, door release, and handset inside to talk/open door release. Handset has 5 wires connected. Is it ok to just loop...
Been asked to advise on a rewire. I think on age alone it's advisable but the following points add to the argument.
Installation age approx 60 years.
This is a "forever Home" so although it may test ok how long will it stay so?
Black T&E throughout. Not a reason to condemn alone but adds to...
Hi Folks
I've just been asked to install an outside socket at a customers house, thats no problem.
My problem is they've got Solar Panels and I've not had the pleasure of working around the extra systems involved.
Can / Should I be able to turn them off whilst I work on the house wiring, do my...
Hi all, it is some time since I visited this site,
but here I am looking for some guidance.
When I last worked seriously on electronics
they were all glass valves, so I know nothing.
I tried to convert a LED work light to infra-red
by removing the bright white lights and fitting
IR lights at...
hi guys could you help me out please.
I have been asked to put a contactor on a 100 amp supply to a dB on a food stand. The contactor needs to shut off on fire through a firetrace system already installed.
1st I was thinking of coming of the dB with a 2a breaker to feed the pressure switch...
hi, I’m new to the forum. I’m an engineer but don’t have electrical qualifications and need some advise on if I need a certified electrician to fit a door bell transformer.
I presently have a mains wired door bell with an integrated transformer which takes mains power supplied by what looks...
Hello all,
I have just had 2x LED down-lighters (ENLITE DE8CX Dimmable, IP65, 8W, integrated LED Fire rated) (from Screwfix) installed, using 1x normal rocker type on/off switch to control both but want to change the switch to a dimmer type. Can you please advise type (preferably Screwfix but...
Afternoon
in the middle of doing my 1st quote for a com/ind setup- bit out of my domestic comfort zone etc!
it is for additional power in workshop units for material testing of composite structure (whatever thats means!!)
see break down of my quote below:
Unit 1 Distribution
1x 6way TPN...
Hi everyone. I am new here.
I completed my L3 c&g 2365 in 2014.
I have not practised since then and have decided to finish off what I started. I hope I have taken the right route... I just registered for ECS H&S and intend following up with 17th edition.
Any advice will be greatly appreciated.
Hi Everyone
I'm hoping you maybe able to give me some advice please. I'm putting on a surprise party for my dad. The venue require any electrical equipment to be pat tested. I am only
Planning on putting 4 wall uplightsers and perhaps a couple of Sets of led fairy lights outside to make it look...
Hi . New to the forum and this is my first post. I am after some advise if you’ll Help please ? I am an electrician with 20 years experience. I am looking into opening my own company. I know all the info on creating the business . Where is the best place to advertise for free? Also, I don’t have...
Hi all can someone give me some advice on what kw heater I can use with this speck
Fuse board b32 rcd
Cable 2.5.....10 metres long just for water heater (nothing else conected)
Water heater will be in downstairs clockroom and use just for hand washing.
What size in kw can I use and how can I...
Morning all,
I've not needed to be here for a long while.
My power one pvi 3.0-outd, has malfunctioned today.
I'm getting Error E031, I can hear the relays clicking away.
I found an Australian youtube video on it, and they seem to think although it can be repaired, it seems its not worth it...
Hello
Im changing my socket ,so red goes in L black in N , but why new socket has 2x holes for green ?
Does it matter which hole they go? Left or
Right side ?
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.