I am working on a study for my brother-in-law who runs a national outdoor catering business. At the moment he uses 3.4kVA petrol generators with Honda engines modified to run on LPG. The maximum steady state load is about 900W but they are sized at 3.4kVA to start in sequence and then run...
Hi forum,
I can't find what this display means on my
- Solis 4G 5kW Solar Inverter - Single Phase - 2 MPPT
LimByPLmt
I have tried contacting them direct & scoured the internet but nobody replies.
Can anyone help.
ive a 3 phase static inverter with a 4 pin no Neutral power output 420 v. Is it possible to use the 240v power source Neutral on the inverter, change the socket output to 5 pin and use the input power source Neutral as in effect a slave Neutral. The Neutral will not be connected to any wiring...
Hi , anyone have a good background in using inverters in off grid system or possible mains & off grid with changeover switch.?
After some info on working out sizing/fusing of inverter, preferably 12vdc-230v ac or maybe 24v dc-230v ac depending on cost and performance differences.
Hope for some...
Hi,
An old customer has asked me to run a health check on their Solar PV system which we installed some 5 years ago. Not something I've done before, beyond the standard installation testing, so I was going to:
Test each panel for Vout against irradiance
Check all electrical connections
Test the...
We've just put in a bread cooling conveyor system. It has two sections, 8ft, and 25ft. Each belt has its own motor, both being 3PH, 230v. Each motor draws approximately 2 Amps. We put in a 5 HP Lenze Inverter Drive to control both motors because, before installing the Drive, both belts were...
My newest inverter has a strange issue - the display quits but the inverter still works.
I verified the voltage/amperage when display was out, and it's still working.
This doesn't seem to affect production, but the intermittent lack of a display is of concern.
Also, the "today's output" is...
I'm considering buying a domestic 4kW PV with 6kWh of battery storage and a 5kW hybrid inverter from Sungrow.
My problem is that wife's electric car has a 7kW Podpoint charger. I assumed that the hybrid inverter would pull power from the grid when the house demand exceeds 5kW, but there's no...
After several asks,been told that an inverter speed controller cannot be used on a 3 phase 2 speed,4 pole motor.
All the tech guys,installers etc,couldn't tell me this at the beginning of job,but when testing the motor,it just didn't sound right,2 motors later one call I've made as finally...
Kindly, we are trying to do a modbus rtu communication between a Delta plc and an ABB solar inverter.
It runs ok during the day, but each night the modbus rtu communication stops due to an unknown cause, and we have to restart the plc each following morning to have everything normal again .
We...
Any tips about putting in an inverter for a 3 p motor,client wants high & low speed,controlled by air sensor relay.
Just wondering who actually commissions & sets all the parameters etc.
Hi all. I recently had a 300w inverter go pop and I'd really like to try to repair it if possible (it's a valuable part of a solar energy system). Upon first inspection, the big metallized polypropylene film capacitor right next to the AC output has burnt. I've no idea if there is any further...
Hi all,
fault on a inverter i installed 5 yrs ago, packed it all in then also so dont know much about these has i havent kept up with it all,
i think the inverter was eversolor if i remember , going to look tomorrow
ive attached piccy if you dont mind looking over guys and if you can help...
Been asked to replace an old consumer unit, PV installed so bonding etc up to scratch.
House supply is TNCS, however with the PV wiring the inverter (Fronius) is on its own earth stake! So that makes 2 earthing systems in close proximity! Why would they want to earth stake the inverter?
Just started doing my solar array. I'm 2391 trained but never done any solar before
Wanted to know do I need to earth my PV rails. I'm using a Solar edge inverter. If so is it 10mm back to board. Thanks.
Also is it worth putting Rcd and M C B straight off AC side of inverter
Hi,
I bought a 4.57Kw PV system (14x SunPower 327W panels) for my house last year.
I now noticed that the installer fitted a SE4000 Solaredge which is limited to 4Kw.
I can see from my stats that the system goes up to 3.98Kw but never above. It just goes flat and stays at 3.98Kw (especially...
Hi
I am buying a new Motor home, & want to do away with my generator.
I know that running an inverter draws a lot of power from a Leisure Battery.
I found this site that recommends connecting a pure sine wave Inverter to the Engine battery, rather than the leisure battery.
I only need to use it...
Hi all
Very strange situation this evening. I installed a PV system around a year ago and has been working fine.
Called out today as the generation meter had stopped increasing. Customers been away and only arrived back today.
Western Power have recently put up a new pole in the customers...
mrrkspark
Thread
between
earth
fault
inverter
polarity
reverse
switched
Hi we noticed our solar must have fused and tripped out the consumer unit for most of September which is really annoying - all that sun! we reset and now it has done it 3 times over this week. What could be the cause? we have never had any problems. We live in Swindon but the installation was...
Yorkie14
Thread
consumer
consumer unit
inverter
old
solar
system
tripping
unit
years
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.